Operation Manual
56
15.2.1.2 Manual configuration
> Select Manual seings and then Cable to start manual configuration.
> Now select whether you wish to automatically retrieve the IP address, gateway etc. from your router
(DHCP active) or to enter it manually (DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway, subnet mask etc. only
works if the DHCP function is activated in your router.
> In sequence, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS (if
required), using the r/s PRESET, VOL+, VOL- buons on the remote control (7, 9, 8, 26).
15.2.2 Connection via WLAN
To configure the network connection via WLAN, you can either use the network wizard or configure this manually.
15.2.2.1 Network wizard configuration
> Select the network wizard to start this.
The network wizard now searches for all the WLAN networks within range and displays them.
> Then select your WLAN network.
You can now choose whether to use the WPS function or whether you prefer to enter your WLAN
password manually.
> If you would like to use the WPS function, launch it on your router as per its instruction manual and then
select Press buon in the network wizard.
Please observe the display overlays. The connection process is generally completed after a few seconds
and the WLAN connection can be used.