Installation Guide Part 2
Table Of Contents
- Technician Operations
- Getting Started
- Testing Alarms
- Configuring the Entry/Exit Delay Periods
- Configuring the Alarm Transmission Delay
- Configuring the Swinger Shutdown Feature
- Resetting the TouchScreen to Factory Defaults
- Checking for New Firmware Updates for the TouchScreen
- Enabling Fire Alarm Verification
- Managing the Physical Devices in the Security System
- Managing Sensors & Zones
- Appendix A: General Concepts of the Security System
- Appendix B: TouchScreen Placement Options
- Appendix C: General Info for Sensor Placement
- Appendix D: Installer Quick Reference (SIA)
Appendix B: TouchScreen Placement Options
79
Appendix B: TouchScreen Placement Options
The TouchScreen can be positioned on a flat surface or mounted to the wall (see page 79). Wherever the
TouchScreen is placed, ensure that it is in a location where its sirens and other audible signals can be
clearly heard by the occupants. Additionally, the TouchScreen should be located where someone
entering the premises can easily access it to disarm it.
Positioning the TouchScreen on a Flat Surface
The TouchScreen can be positioned on a flat surface.
Recommendations:
Position the TouchScreen on a flat surface that is not subject to vibrations or wobbles.
Ensure the flat surface is not subject to traffic that could topple it or bump the TouchScreen.
Position the TouchScreen near an unswitched wall outlet (not controlled by a light switch).
Do NOT position the TouchScreen near a cordless phone stand or microwave as these devices
could interfere with the communication with the sensors.
To install the TouchScreen to be positioned on a flat surface, use the instructions on page 1.
Mounting the TouchScreen on the Wall
Rather than placing the TouchScreen on a table, desk, or counter,
the device can be mounted on the wall using the wall mount.