Installation Manual

ManualsBrandsTechni Mobili ManualsFurnitureTechni Mobili Mid-Back Mesh Task Office Chair with Height Adjustable Arms, Gray

Place the folded Back/Seat/

Armrest (B) upside down

with its front facing away

from you as shown. Assemble

the mechanism (B) using

screws (F), but screw loose

and tighten after all screws

are in place.The handle will

be on the left side as shown.

PARTS LIST

ATTENTION: Before you begin to assemble the product, please make

sure that all the parts are included in the package, and

inspect them for damages or defects.

(A)x1

Back/Seat/Arms

(B)x1

Mechanism

(C)x1

Gas Lift

(D)x1

Base

(E)x5

Casters

(F)x4

Screws M6x20mm

(G)x2

Screws M6x25mm

(H)x4

Cap Cover

(I)x1

Allen key

ASSEMBLY INSTRUCTIONS CHAIR STYLE RTA-8030

Insert all the casters(E)

into the base (D) using

pressure, then place

the gas lift (C) in the

middle of the base (D).

Place the cap covers (H) over

the holes on the sides.

DONE! Enjoy your new chair!

Make sure that all the

screws, bolts and knobs are

tightened before using the

chair for the first time.

ATTENTION:

- To avoid misalignments, leave the screws

loose and do not tighten them until all are

in place.

- Do not overtighten or force the screws as they

could break or strip.

- Using the wrong size of screws on a part might

cause damage to it.

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

Secure the backrest with

screws (G) on each side

as shown, make sure the

bottom two screws are

tighten.

(2 on each

side)

(On both

sides)

Place the top parts of the

chair over the base parts,

making sure that the tip

of the gas lift enters into

the hole of the

mechanism. Then unfold

the backrest.

Summary of content (2 pages)

PAGE 1
® ASSEMBLY INSTRUCTIONS CHAIR STYLE RTA-8030 PARTS LIST ATTENTION: Before you begin to assemble the product, please make sure that all the parts are included in the package, and inspect them for damages or defects.
PAGE 2
® LIFT AND TILT FUNCTIONS: - To raise or lower the chair’s height: Pull the handle UP with force. The chair will go down while sitting on it, or up if you lift your body. - Tilting mechanism: Pull the handle OUT (horizontally) to unlock and IN to lock. - Tilt tension control: Turn the mechanism’s knob either direction to apply more or less tension to the tilting function. - Arm height: Push the buttons and raise or lower the arms to the desired height. WARNINGS: - Do not stand up on the chair.