Operation Manual

Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
9
Assembly page 9/29
Fax +32 2 359 95 50
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp plug is
used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power socket before fitting or removing accessories!
Insert the connection wand into hose connection inlet until it locks (Fig. 1).
Connect both parts of the tube.
Fitting the tube to the handle (Fig. 2).
Fitting the tube to the desired brush (Fig. 3).
The floor brush is ideal for the daily cleaning of carpets and hard floors.
Press the lever (A) for cleaning hard floors.
Press the lever (B) for cleaning carpets.
The appliance is delivered with a small brush for furniture, Venetian blinds, books, lamp shades
and shelves.
OPERATIONS
Pull out a sufficient length of power cord and insert the plug into the power socket. A yellow
mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red
mark.
It is advisable to set the electronic power regulator to MIN before switching the appliance on. By
turning the regulator button, the suction power can be adjusted.
WHEN CLEANING IS FINISHED
Stop the vacuum cleaner by depressing on the switch button.
Disconnect plug from electrical outlet.
Simply press lightly with your foot on cable rewind button on top of cleaner.
Replacing the dust bag
Always operate the cleaner with dust bag installed.
Disconnect from electrical outlet before changing dust bag.
Lift dust cover catch and raise dust cover.
Remove bag collar from bag holder and pull out dust bag.
Put in new dust bag and close the dust cover.