Manualshelf

Manual

ManualsBrandsTeachLogic ManualsAudioVOICELINK III
11121314151617181920
owner’s manual
10
VoiceLink III
projector system setup
• With the ceiling sensor installed, connect it to
the VoiceLink III sensor input
• Locate VoiceLink III near projector and connect
to AC power
• Connect an audio cable with 3.5mm connectors
from projector audio output to VoiceLink III
COMP/AUX/DVD Input (front panel)
• Connect VoiceLink III output to power amplifier:
• Shielded two-connector cable connected to
3 pin balanced output per page 7.
• Shielded audio cable with 1/4" phone from
unbalanced output to amplifier mic input.
• Turn "on" VoiceLink III, Power Amplifier, and
Video Projector
• Set “COMP/AUX/DVD IN” control on VoiceLink
III to 2 o’clock position
• Set Power Amp volume (if applicable) mid scale
• With microphone turned “on”, speak and adjust
microphone volume using “CH A” or "CH B"
volume control on VoiceLink III
• With an Auxiliary program turned “on” and
plugged into the projector, adjust the auxiliary
volume with the remote control
• Some adjusting of the VoiceLink III (COMP/
AUX/DVD) and amplifier volume may be required
• Once auxiliary volume is optimized, readjust
microphone volume using “CH A” or "CH B"
volume control
• System is now ready to use with remote control of
AUX inputs and consistent Mic volume
(Mic volume does not change with remote
volume control)
Microphone volume is
not affected by the remote
control of the auxiliary
inputs.
note
How to Interface VoiceLink III with a Video Projector
and incorporate the Projector’s Remote Control
Infrared Transmitter
“Sapphire” IRT-55
Speakers