User's Manual

transmitterowner’s manual
14
Forum 232
system operation
•
On Forum 232 set Ch A & B volume controls to o
(counter clock wise)
• Turn the Forum 232 “ON”, Blue LED will light
• Conrm power to ceiling sensor, Green LED on edge
of sensor will light
• Using a Sapphire Transmitter microphone. (Sapphire
Mics are shipped in channel A)
• Sapphire:
“A–B” switch, remove battery cover
on back, under battery.
• Handheld: Unscrew barrel and remove.
Note “A–B” switch on side of battery holder.
• Turn sincitivity control on Sapphire transmitter to
"HI" level position
• Switch transmitter “on” by depressing and hold front
button until (Blue) LED is present
• Observe signal presence LED (Orange) on Forum 232
receiver adjacent to “Mic” volume control
• Stand under or in front of a speaker
• Slowly adjust “Ch A” volume on Forum 232 while
talking into microphone
• Adjust to desired listening level.
CAUTION: Beware of feedback
• Walk around the room while talking into microphone
to conrm good connectivity
Upon completion of performance test,
the installation is complete.
operation of wireless microphone
Now that the system is installed and connected, we are ready to turn the system “ON” and test
its performance. e testing will be done using an IR transmitter (Sapphire or Handheld) to
conrm good connectivity and quality audio.