User's Manual

Optional:
Two Additional Speakers
owner’s manual
8
installation of speakers
installing two SP-628 ceiling speakers
•
Determine the listening area.
• Divide listening area into two quadrants
• Locate and identify the center most tile in each quadrant
• Lay ceiling tile face down on clean  at surface
• Lay tile bridge on ceiling tile and center it
• Trace and cut the large hole using a keyhole or drywall
saw
• Strip the speaker cable ends, approx. ½"
• Route speaker wire from speaker opening to ampli er
• Reinstall ceiling tile with tile bridge in place above the
hole
• Pull speaker cable back down through speaker hole
• With a pointed tool or paper clip, li up and remove
speaker grille
• Set speaker on top of ladder and connect speaker cable
connect
• Observe speaker polarity, connect Red wire to (+)
terminal and black wire to the (C) terminal
• With the mounting clamps folded back, position
speaker into speaker hole
• With a #2 Phillips screwdriver, tighten the quick clamps
• Reinstall speaker grille and remove any soil or
 ngerprints
• Repeat same for other speaker
Two wall mount or ceiling speakers can be powered by the receiver/ampli er. It has two ampli ers
(25 watts ea.). One speaker will be connected to each ampli er.
Optional: Two additional speakers can be powered by the ampli er. Connect two speakers in
parallel.  en bring a cable from each pair to the ampli er. Connect one pair to each ampli er.
Forum 232