User manual

Locking Clip Contacts and Housings
114- 25006
Rev F 5 of 9Tyco Electronics Corporation
8. Vertical Alignment
The contact, including the cutoff tab and burr, may not be bent above or below the datum line more than
is shown in Figure 5.
3_
(Max)
3_
(Max)
Datum Line
Figure 5
9. Horizontal Alignment
The side to side bending of the contact may not exceed the limits shown in Figure 6.
Figure 6
3_
(Max)
3_
(Max)
Datum Line
10. Twist or Roll
There should be no twist or roll of the crimped portion in relation to the uncrimped portion of contact that
could impair its use. See Figure 7 for limits.
Figure 7
Datum Line
Avoid Twist
and Roll
Crimped Portion
Uncrimped Portion
5_
(Max)
5_
(Max)
C. Insulation Barrel Crimp
The insulation barrel crimp height and width are given in Figure 4.
DO NOT cut or break the insulation while crimping contact.
CAUTION
!