Information

All specifications subject to change. Consult TE Connectivity for latest specifications.
VII
Quality Guidelines
Timer Interconnection System
Catalog 889759-3
Revised 7-2011
F-CRIMP
For double wire applications with different size wires always place wire with
smallest outer diameter in the bottom
Insulation is securely held
Crimp barrel closed
Bellmouth must always be present
Locking lances and terminal
body not deformed
Bellmouth Permissible
Cut off tabs present
Crimp barrel is closed, legs support each other Sufficient gap between legs and bottom of crimp
All strands are equally distributed and deformed
Insulation is securely held
Legs overlap
Insulation securely held
Legs must pass each other
OVERLAP CRIMPWRAP OVER
CRIMP
Correct selection of wire, terminal and applicator
WIRE CRIMP
WIRE CRIMP
INSULATION CRIMP
Correct Insulation Diameter, Applicator and Terminal
Examples:
Con- Part Wire Toler- Appli-
tact No. Range ance cation
(mm
2
) (mm) Spec.
MQS 962885 0.2–0.5 ± 0.03 114-18025
962886
JPT 927775 0.5–1.0 ± 0.05 114-18050
JPT 927773 1.5–2.5 ± 0.05 114-18050
Digital Crimp Height Micrometer
(0.001 mm increments) acc. to DIN ISO 9001
Part No. 547203-1
Crimp height measurement
Crimp heights and tolerances
For crimp height tolerances for any given
contact, please refer to the relevant
application specification.
INSULATION CRIMP
Test
30°
30°
Wire crimp without conductor
Insulation must be
securely held
after bend test
Insulation Present
Conductor Present
Correct