Information

108-2184
Test Description Requirem ent Procedure
Therm al shock. See Note. SAE J2030 6.13.
Subject specimens to 10 cycles
between -40 and 120°C .with 1 hour
dwells at tem perature extrem es.
Sealing pressure. 35 kPa, pre-test, no bubbles.
35 kPa, post-test, no bubbles.
EIA-364-2.
Subject specimens to specified
pressure for 30 m inutes.
Pressure washing. See Note. SAE J2030 6.5. and SAE J1455
4.5.
Subject specimens to spray for 3
seconds of a 6 second period for a
total of 375 cycles consisting of a
volume of 9.46 liters per m inute at a
pressure of 7000 kPa and a
temperature of 40°C from a
distance of 20 to 30 cm. No
detergent.
Chem ical exposure. See Note. SAE J2030 6.14.
Subject specimens to 5 cycles of a
5 minute dip in the following
chemicals followed by air drying for
24 hours:
1) Diesel fuel at 60 ± 3°C;
2) Engine oil at 100 ± 3°C;
3) Transm ission drive train oil at
100 ± 3°C;
4) Final drive axle oil at 100 ± 3°C;
5) Ethylene glycol (50% ) and water
(50%) at 100 ± 3°C;
6) Propylene glycol (50%) and
water (50% ) at 100 ± 3°C;
7) Brake fluid at 25 ± 3°C.
Salt exposure. See Note. SAE J2030 6.12. and ASTM B117.
Subject specimens to a 5% salt
solution at 35°C for 96 hours.
Steam cleaning. See Note. SAE J1455 4.5.
Subject specimens 375 cycles
lasting 18.75 minutes of pressure
washing at 85°C consisting of a
volume of 9.46 liters per m inute at a
pressure of 1400 kPa from a
distance of 20 to 30 cm. No
detergent.
Shall meet visual requirements, show no physical damage, and meet requirements of additional
NOTE
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure
3.
Figure 2 (end)
Rev B 4 of 6