Information

Basic Part No. 215570
Micro-MaTch Miniature Connector System
Paddle Board Connector
Direct soldering of a ribbon cable onto a PC Board is a very difficult
job with the smaller sizes of ribbon cable. If such a permanent cable
connection is required, the application can be facilitated by using this
connector type.
The Paddle Board connector is applied to the ribbon cable with the
same application tooling, available for the termination of the
Male-on-Wire connector.
The solder legs are indented and provide mechanical retention of
the connector/cable assembly in the PC Board before and during
soldering.
This Paddle Board connector version is designed to be soldered onto
PC Boards with a nominal thickness of 1.6 mm.
Notes:
1. Connectors are always sideways mounted onto
an adhesive tape.
2. Standard packaging quantity is 2500 connectors
on a reel with a diameter of 600 mm.
3. At additional charge a special packaging option is
available: 250 connectors on a reel with a diameter
of 250 mm packed in a dedicated dispenser box.
11
All specifications subject to change. Consult Tyco Electronics-AMP for latest design specifications.
No. of Positions Dimensions mm Part Numbers
ABC2500 Connectors/Reel 250 Connectors/Box
4 8.6 5.4 3.81 1-215570-4 7-215570-4
6 11.1 8.0 6.35 1-215570-6 7-215570-6
8 3.6 10.5 8.89 1-215570-8 7-215570-8
10 16.2 13.0 11.43 1-215570-0 8-215570-0
12 18.7 15.6 13.97 1-215570-2 8-215570-2
14 21.3 18.1 16.51 1-215570-4 8-215570-4
16 23.8 20.7 19.05 1-215570-6 8-215570-6
18 26.3 23.2 21.59 1-215570-8 8-215570-8
20 28.9 25.7 24.13 2-215570-0 9-215570-0
"A" MAX.
A
A
1.5
"B" MAX.
"C"
8.3
2.54
1.27
SECTION A-A
6.8
0.80
1.50
1.80
1.27
2.54
2.54
HOLE FOR POLARIZATION
TYPICAL HOLEPATTERN
NOT SOLDERSIDE SHOWN
1.40
5.1 MAX.
2.54
3.1