Information

Typical Die
Assembly
114- 40030
Rev D12 of 13
Figure6(end)
Miscellaneous
Tooling
Shielding Enclosure Expansion
Tool 58241--[ ]
Insertion/Extraction
Tool 91285--1
Seating Fixture Assembly
543615--1
5.2. Single Cable- to- Shield Ferrules
The dies listed in the table in Figure 7 must be inserted into the hand tools and automatic machine die holder
that uses them. Die sets with base PN 58237 (Instruction Sheet 408--9242) and 58238 (Instruction Sheet
408--9243) are used in Hand Crimping Tool 543344--1 (Instruction Sheet 408--9315), or in Die Holder 58449--1
(Instruction Sheet 408--9721) powered by Pneumatic Power Unit 312522--3 (Customer Manual 409--5843). Die
sets with base PN 543424 (Instruction Sheet 408--9507) and 543425 (Instruction Sheet 408--9508) are used in
Hand Crimping Tool 543344--1 (Instruction Sheet 408--9315) only.
Crimp dimensions for ferrules will fall within proper guidelines when dies are seated in the appropriate tooling and
properly gaged. Gaging information is contained in instruction sheets corresponding to the dies. All braided cable
shielding should be folded forward and distributed evenly before sliding and crimping the ferrule into place.
HARDWARE
SHELL
SIZE
CABLE
DIAMETER
ACCEPTED
DIE
SET
1, 2, 3
4.19--4.83 [.165--.190] 543424--3
,
,
4.83--5.51 [.190--.217] 543424--2
5.51--6.25 [.217--.246] 543424--8
6.25--7.21 [.246--.284] 543424--1
7.21--8.23 [.284--.324] 543424--7
8.23--9.52 [.324--.375] 543424--6
9.52--11.10 [.375--.437] 543424--5
10.16--11.56 [.400--.455] 543424--4
4, 5
5.84--6.73 [.230--.265] 543425--2
,
8.58--9.78 [.338--.385] 543425--1
9.52--10.97 [.375--.432] 58238--1
10.72--12.45 [.422--.490] 58237--2
12.19--14.27 [.480--.562] 58237--1
Figure 7
NOTE
i