Information

108-10024-4
3.6. Product Qualification and Requalification Test Sequence
Test or Exam ination
Test Group (a)
1 2
Test Sequence (b)
Initial exam ination of product 1 1
Tem perature rise vs current 2
Contact retention 2
Final exam ination of product 3 3
(a) See paragraph 4.1.A.
NOTE
(b) Numbers indicate sequence in which tests are performed.
Figure 2
4. QUALITY ASSURANCE PROVISIONS
4.1. Qualification Testing
A. Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall each consist of 3 specim ens.
B. Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
4.2. Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
4.3. Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specim ens resubm itted for qualification. Testing to
confirm corrective action is required before resubmittal.
4.4. Quality Conformance Inspection
The applicable AMP quality inspection plan shall specify the sam pling acceptable quality level to be
used. Dim ensional and functional requirem ents shall be in accordance with the applicable product
drawing and this specification.
Rev B 3 of 4