Information

202
Catalog 82181 Dimensions are in inches and Dimensions are shown for USA: 1-800-522-6752 South America: 55-11-2103-6000
Revised 2-07 millimeters unless otherwise reference purposes only. Canada: 1-905-470-4425 Hong Kong: 852-2735-1628
specified. Values in brackets Specifications subject Mexico: 01-800-733-8926 Japan: 81-44-844-8013
www.tycoelectronics.com are metric equivalents. to change. C. America: 52-55-1106-0803 UK: 44-8706-080-208
Application Tooling (Continued)
AMP
Soft Shell
Pin and Socket Connectors
Application Tooling
Automatic Machines
EDGE Electronic Applicator
Counter
Fully-automatic machines
that measure, cut, strip
and terminate single leads.
Microprocessor-controlled, and
programmed and operated
using an easy-to-follow, menu-
driven touchscreen. Features
include direct-drive terminating
units with precision crimp height
adjustment, fully programmable
setups, wire runout and splice
detection, and motorized
pre-feed with wire straightener.
Crimp quality monitoring is
also available.
Specifications
Width—159 [4 039]
Depth—68 [1 730]
Height—90 [2 285] min., with
24 [610] dia. reel
Weight—2 000 lb [907 kg]
Electrical—220 VAC, 50 or 60 Hz,
1 ∅, 20 A with neutral and ground
Air—90 psi [6.21 bar], 15 scfm
[0.00708 m
3
/s] sustained
Wire Range—26-10 AWG
[0.12-6 mm
2
] stranded, 26-16 AWG
[0.12-1.4 mm
2
] solid
Lead Lengths—3-90 [76.2-2 286],
90-1 000 [2 286-25 400] with long lead
conveyors
For more information, request Catalog
124324.
AMPOMATOR CLS IV+
Lead-Making Machines,
356500-1, -2
The AMPOMATOR System III
Leadmaker is designed for
the demands of low-volume/
high-mix manufacturing and
precision quality. This lead-
maker combines the best wire
processing capabilities with
new technologies in terminal
feeding and machine set-up
found in the System III
Applicator to offer significant
advantages for higher through-
put and efficiencies.
Request Catalog 1654956-5.
AMPOMATOR System III
Leadmaker
The new, versatile EDGE appli-
cator counter tracks wearable
tool usage for the most effec-
tive maintenance planning. The
completely electronic counter,
with clear LCD display, indi-
cates cycles since installation.
By performing maintenance at
measured intervals with pre-set
limits, operators avoid break-
downs and rejects caused by
tool wear or mis-adjustment.
For more information, request Catalog
1773385.
The System III Applicator
introduces several new
technologies into the applicator
including a precision servo-
electric motorized feeding
system, a built-in data module
for storing terminal crimp and
set-up information, a precision
fit round ram, and a newly
designed terminal depressor.
It still utilizes the proven quality
of the HD-M crimper and
anvil tooling.
System III Applicator