Information

107
Catalog 82004 Dimensions are shown for Dimensions are in inches and Canada: [phone] UK: [phone]
Revised 3-11 reference purposes only. millimeters unless otherwise Mexico/C. Am.: [phone] France: [phone]
Specifications subject specified. Latin/S. Am.: [phone] Netherlands: [phone]
www.te.com to change. USA: [phone] Germany: [phone] China: [phone]
Application Tooling (Continued)
FASTON Terminals (Insulated and Uninsulated)
Application Tooling
Automatic insertion
machines for the application
of reeled pins, tabs and
receptacles. Available with
up to 3 insertion heads to
apply different products.
The PCB is positioned by
an XY table powered by
stepper-motors (optional
servo drives for higher
insertion rates). Available
in stand-alone or inline
(SMEMA) configuration for
fully automatic operation.
Optional equipment
includes insertion force
monitoring, vision system,
board thickness
measurement and
adjustable lower anvil.
P300 and P350 Automatic
Insertion Machines
Specifications
Width — 57.5 [1,460]
Depth — 64.5 [1,640]
Height — 60 [1,520]
Weight — Depending on configuration
Electrical — 110 V, 60 Hz
Air — 87 psi [6 bar]
Insertable Area — 24 x 16
[600 x 400]
For more information, contact TE.
Product Features
■ Board capacity of 305 x
450 mm [12 x 18"]
■ X/Y-Table with stepper
motors
■ Database driven software
for simple programming
and automatic setup
■ “Quick change” tooling
packs allow easy and fast
setup
■ Wide range of tooling
packs for TE and non TE
products available
■ Easy-to-use operator
interface
Designed and manufactured
with a focus on mid-volume
level production, the
AccuSerter 2 machine
provides a broad range
of features at a very
competitive price. It uses a
pneumatic power unit
together with product
specific “quick change”
tooling packs. The insertion
heads can be equipped
with a rotary insertion finger
that can apply products at
different angles without
decreasing the insertion
rate. The tooling packs
can be exchanged within
30 minutes to meet your
full range of application
requirements.
The lower support tool is
equipped with an electrical
continuity or pin penetration
check to assure that each
product was correctly
inserted into the PCB and
remained there in real time.
There is no additional
quality check required and
all QC data can be stored
via the system PC for 100%
future traceability.
Note: The AccuSerter 2 machine is not
CE approved.
AccuSerter 2 Pin Insertion
Machine