Information

114-13065
2 of 10
Rev C
2. REFERENCE MATERIAL
2.1. Revision Summary
Revisions to this application specification include:
• Changed product code in Paragraph 2.2
• Deleted text in CAUTION in Paragraph 3.3 and 3.3.A.5
2.2. Customer Assistance
Reference Product Base Part Number 776494 and Product Code M097 are representative numbers that identify
the AMPSEAL 16 Connector product line. Use of these numbers will identify the product line and help you to
obtain product and tooling information. Such information can be obtained through a local Representative, by
visiting our website at www.te.com
, or by calling PRODUCT INFORMATION or the TOOLING ASSISTANCE
CENTER at the numbers at the bottom of page 1.
2.3. Drawings
Customer Drawings for specific products are available from the service network. The information contained in
Customer Drawings takes priority if there is a conflict with this specification or with any other technical
documentation supplied by TE.
2.4. Specifications
Refer to Application Specification 114-13045 for information on application requirements on pin and socket
contacts that fit into the AMPSEAL 16 Connector System.
2.5. Instructional Material
Instruction Sheet 408-8623 provides assembly and disassembly procedures for the AMPSEAL 16 Connector
System.
3. REQUIREMENTS
3.1. Storage
A. Reel Storage
When using reeled contacts, store coil wound reels horizontally and traverse wound reels vertically.
B. Connector Storage
Store connector assemblies in the shipping containers until ready for use.
C. Shelf Life
The contacts should remain in the shipping containers until ready for use to prevent deformation to the
contact. The contacts should be used on a first in, first out basis to avoid storage contamination that could
adversely affect signal transmissions.
D. Chemical Exposure
Do not store contacts near any chemicals listed below as they may cause stress corrosion cracking in the
contacts.
Alkalies Ammonia Citrates Phosphates Citrates Sulfur Compounds
Amines Carbonates Nitrites Sulfur Nitrites Tartrates
NOTE
Where the above environmental conditions exist, phosphor-bronze contacts are recommended instead of brass if available.
3.2. Characteristics
A. Materials
The cap and plug assemblies are made from glass filled thermoplastic while the peripheral and wire seals are
made from silicone rubber. The pin contacts are made of brass and the socket contacts are made of a copper
alloy. Both contacts are available in gold or nickel plating and are available with or without an insulation barrel.
NOTE
i