Datasheet

114- 40005
Rev H 5 of 9
3.3. Product Selection
The specific acceptable pin length range for AMP--LATCH Novo Receptacles is 4.44--6.22 [.175--.245].
Figure 3 shows relationships between available receptacles and the connectors that will mate with them.
MATING
POLARIZATION OPTIONS
M
A
T
I
N
G
CONN ECTOR TYPES
MILITARY
CENTER AND MILITARY DUAL
Pin Connector with or without Mounting Ears X X X
Pin Connector with or without Mounting Ears
and with Detent Windows
X X X
Bulkhead Pin Connector X -- -- -- X
Universal Ejection Style Pin Header X X X
Military Ejection Style Header X X -- -- --
Low--Profile Pin Header X X X
High Temperature Universal
Ejection Style Pin Header
X X X
Universal Ejection Style Pinless Header X X X
Stacked Headers X X X
AMPMODU* HeadersU
X -- -- -- X
U Only headers that have a 3.81 [.150] end dimension will mate.
Figure 3
A. Polarization and Strain Relief
Polarization has been designed into the housings of Novo receptacles.
B. Military, Center, and Dual Polarization
Receptacles with military polarization can be used in all header and plug connectors. Those with a
combination of military and center polarization, and those with dual polarization can only be used with
header or plug connectors that have the respective type of center or dual polarization.
C. Receptacle Cover Options
Covers are designed for either feed--through or end--of--line applications.
3.4. Terminated Receptacle Requirements
Prepared cable shall be terminated according to the procedures given in the applicable tooling instructions.
See Paragraph 2.3, for details on tooling options and instructional materials. Figure 4 shows criteria for
acceptable terminations.
Reasonable care should be taken by tooling operators to provide undamaged terminations. An improper termination in
any of the IDC contacts will be reason to discard the entire receptacle. Contacts are designed for one--time
termination, and cannot be replaced, repaired, or re--used.
NOTE
i