User's Manual

uncontrolled environment and are safe for intended operation as described in this
manual. The further RF exposure reduction can be achieved if the product can be kept as
far as possible from the user body or set the device to lower output power if such
function is available.
RF exposure information (SAR)
This product is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications Commission
of the United States.
The exposure standard for wireless devices employing a unit of measurement is
known as the Specific Absorption Rate, or SAR.
The exposure standard for wireless devices employing a unit of measurement is
known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg.
This device is complied with SAR for general population /uncontrolled exposure
limits in ANSI/IEEE C95.1-1992 and had been tested in accordance with the
measurement methods and procedures specified in IEEE1528. This device has been
tested and meets the FCC RF exposure guidelines when tested with the device directly
contacted to the body.
For this device, the highest reported SAR value for usage near the body is
0.485W/kg. While there may be differences between the SAR levels of various products
and at various positions, they all meet the government requirements.
Specific Absorption Rate (IEEE)
THIS DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO
WAVES.
Your device is a radio transmitter and receiver. It is designed and manufactured not to exceed the
emission limits for exposure to radio-frequency (RF) energy. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. These guidelines include a substantial safety margin designed
to ensure the safety of all persons, regardless of age and health.
The exposure standard for device employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by public authorities such as the Federal Communications Commission of the US Government
(FCC), or by Industry Canada, is 1.6 W/kg averaged over 1 gram of body tissue. Tests for SAR are conducted using
standard operating positions with the device transmitting at itshighest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. This is because the device is designed to operate
at multiple power levels so as to use only the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power output of the device. Before a device
model is available for sale to the public, compliance with national regulations and standards must be