User's Manual

21
Model 104 Important: Operator Checklist
Section 7 Important: Operator Checklist
During Cleaning and Sanitizing
ALWAYS FOLLOW LOCAL HEALTH CODES.
Cleaning and sanitizing schedules are governed by
your State or local regulatory agencies and must be
followed accordingly. The following check points
should be stressed during the cleaning and sanitizing
operations.
We recommend that after the necessary batches
have been prepared for the day, the machine
should be cleaned. At the beginning of each day
the machine should be sanitized.
Troubleshooting Bacterial Count
j 1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j 2. Use all brushes supplied for thorough cleaning.
The brushes are specially designed to reach all
mix passageways.
j 3. Use the white bristle brush to clean the mix inlet
hole which extends from the top down to the
rear of the freezing cylinder .
j 4. Use the black bristle brush to thoroughly clean
the rear shell bearing located at the rear of the
freezing cylinder . Be sure to have a generous
amount of cleaning solution on the brush.
j 5. Using a screwdriver and cloth towel, keep the
female hex drive socket and rear shell bearing
clean and free of lubricant and mix deposits.
j 6. Properly prepare the cleaning or sanitizing
solutions. Read and follow label directions
carefully. Too strong of a solution may damage
the parts and too weak of a solution will not do
an adequate job of cleaning or sanitizing.
j 7. The temperature of liquid mix should not exceed
40_F. ( 4. 4_C.).
j 8. Follow your local health codes when using
flavorings, fruits, or nuts in this machine.
Regular Maintenance Checks
j 1. Check the rear shell bearing for signs of wear
(excessive mix leakage in rear drip pan) and be
certain it is properly cleaned.
j 2. Dispose of seals if they are worn, torn, or fit too
loosely, and replace with new ones.
j 3. Follow all lubricating procedures as outlined in
“Assembly”.
j 4. Replace scraper blades that are damaged or
nicked. Before installing the beater assembly,
be certain that scraper blades are properly
attached to the beater assembly.
j 5. If your machine is air cooled, check the
condenser for accumulation of dirt and lint. Dirty
condensers will reduce the efficiency and
capacity of the machine. Condensers should be
cleaned monthly with a soft brush. Never use
screwdrivers or other metal probes to clean
between the fins.
Note: For machines equipped with an air filter,
it will be necessary to vacuum clean the filters
on a monthly schedule.
Winter Storage
If the place of business is to be closed during the winter
months, it is important to protect the freezer by
following certain precautions, particularly if the
building is to be left unheated and subject to freezing
conditions.
Disconnect the freezer from the main power source to
prevent possible electrical damage.
Wrap detachable parts of the freezer such as beater,
blades, drive shaft, and freezer door, and place in a
protected dry place. Rubber trim parts and gaskets
can be protected by wrapping with moisture--proof
paper. All parts should be thoroughly cleaned of dried
mix or lubrication accumulations which attract mice
and other vermin.