Installation Guide

Read this assembly manual carefully, and verify that you have all the parts listed before you begin.

Keep your assembly manual for future reference.

Move this stand gently with 2 persons.

Protect finishes by placing furniture pieces on a soft carpeted surface during assembly.

Do not place very hot/cold objects on top of any surface. Always use a coaster or mat. Never leave

liquids on the surface: Clean immediately with a mild soap and a damp cloth. Never use scouring

powder based cleanser. Don't touch the glass surface with a hard/acute object it may cause the glass

to shatter.

DO NOT ASSUME CHILD SAFETY WITH ANY PIECE OF FURNITURE!

Do not allow children to climb on furniture. Improper use can cause death or serious injury. If you are

placing a TV on top use safety straps on your TV to prevent the risk of a toppling television. Furniture

straps fastened to a wall can also be used to help ensure safety.

Damaged parts or furniture put together incorrectly can lead to serious injuries. Make sure to follow

instructions correctly.

1 x1

2 x1

3 x1

A x36 B x1

E x4

C x2

Model No.:

SY2201

Page 1 of 5

G x1

x12

4 x1 5 x1

6 x3

7 x1

8 x1

9 x1

10 x1

D x3

F x3 H x2

11 x1

I x1 J x4

Tools Requred(Not included)

A1 A2

PAGE 1
Model No.: SY2201 Read this assembly manual carefully, and verify that you have all the parts listed before you begin. Keep your assembly manual for future reference. Move this stand gently with 2 persons. Protect finishes by placing furniture pieces on a soft carpeted surface during assembly. Do not place very hot/cold objects on top of any surface. Always use a coaster or mat. Never leave liquids on the surface: Clean immediately with a mild soap and a damp cloth.
PAGE 2
x12 A2 3 A2 4 x1 6 x1 A1 x8 1 x1 10.
PAGE 3
6 x6 A2 7 5 5 x1 8 x1 8 180° 10 8 D x3 F x3 I x1 9 x1 D x1 D 11 F I D Page 3 of 5
PAGE 4
E x4 H x2 H E Insert B into the groove at the bottom of the door panel x10 A2 1 A2 180° Page 4 of 5
PAGE 5
14 J x4 15 C x2 L WAL L WAL J Insert J into the gap between the back panel and the side panel, and then lock with self-tapping screw 16 C WAL L Position the wall plate at your desired height and ensure the wall plate is horizontal. Mark well and punch. x2 17 L WAL Make the screw through the hole on NO.2 NO.5 and NO.