Owner's Manual

98 TASCAM HS-2
Changing the password settings
Touch the Change button located near Password on the
ETHERNET page of the REMOTE SETUP screen to open
the CHANGE PASSWORD screen enabling you to set the
password.
Up to nine characters can be entered.
Network functions (FTP/ telnet / VNC)
FTP (File Transfer Protocol)
Use a FTP client application to transfer files between this
unit and a computer system. Connect with this unit and
log in like other FTP servers.
Connect with this unit and log in to display [A:], [B:], [C:]
on the root directory. These correspond to [SD], [CF] and
[USB], respectively.
If there is no media storage device loaded, the contents
of the corresponding directory [A:], [B:] or [C:] will not be
shown.
NOTE
•
Use an FTP application which is compatible with
Unicode if you want to display Japanese characters.
•
Be sure to set the maximum simultaneous transfer
number of the FTP client applications to “1”.
If a number other than "1" is set, file transfer may not
be possible.
•
Consult with TASCAM Customer Support for details on
FTP client applications that have been tested with this
unit.
•
Settings necessary to connect via FTP
The setting values necessary to connect FTP with this
unit are as follows:
IP Address : The IP Address of this unit is shown on the
IP Address in ETHERNET page of the RE-
MOTE SETUP screen.
Port number : 21
User name : ”HS-2”
Distinguishes between capital letters and
small letters.
(You can not change this)
Password : The default password is “HS-2”.
Distinguishes between capital letters and
small letters.
You can change the password with the
Password [Change…] button in ETHER-
NET page of the REMOTE SETUP screen.
NOTE
•
Only one FTP connection can be active at a time.
•
Because some FTP client applications may allow you
to start multiple FTP connections to the same unit, you
may not be able to transfer files correctly. Avoiding
having 2 FTP connections simultaneously.
•
If the EXTERNAL Control on the LOCK SETUP screen
is set as LOCK, you cannot connect via FTP.
•
If the External LOCK setting is enable when an FTP
connection is active, that FTP connection will be
disconnected.
•
If you change the setting on ETHERNET page of REMOTE
SETUP during the FTP connection, the FTP connection
is disconnected.
•
File operations by FTP client application
1. Reading out the file from this unit.
Reading out the file from this unit is always possible.
2. Adding a new file to this unit
Adding a new file to this unit is always possible.
If BWF file or WAV file is added to the current session during
recording, it will be displayed on the list in the order of the
existing file, recording file and additional file.
3. Overwriting this unit on the existing file
Overwriting on the current take is possible only during stop.
Takes which are being used on the entry edit screen of the
playlist mode cannot be overwritten. Overwriting on the ex-
isting files other than this is always possible.
However, if the PLAY SETUP screen is on the playback
with Play Mode of GENERAL page is set as All Take ,
overwriting the take that follows the current take may be de-
pendent on the timing of the write access..
CAUTION
If you overwrite the take assigned on the playlist entry in
the playlist mode, a “?” mark is shown on the applicable
entry icon on the entry list screen or file assignment
screen and the entry will no longer be playable. Assign
the overwritten file on the entry once again to enable you
to play back the overwritten file.
10–Internal settings