Owner's Manual

TASCAM HS-2 39
Editing the name of the first session
Touch the Session Name button on the CREATE
PROJECT screen to open the 1st SESSION screen, as
shown below.
Follow the same procedures as in “Editing the project
name” on page 38 to change the name.
NOTE
Session names cannot be changed later.
Loading projects
1 Press the PROJECT key on the front panel to open
the PROJECT screen.
2 Select the project that you want to load.
3 Touch the MENU button on the PROJECT screen to
open a pull-up menu.
4 Touch the LOAD button in the pull-up menu.
NOTE
When multiple projects are selected, the LOAD item is not
available.
5 Touch the OK button or press the DATA dial when
the confirmation pop-up message appears.
After loading completes the Home Screen opens.
Rebuilding projects
Rebuilding (file rescan) should be performed whenever
there is an inconsistency between the unit's file lists and
the actual directory contents that may occur, for example,
when an audio file has been deleted via FTP.
1 Press the PROJECT key on the front panel to open
the PROJECT screen.
2 Select the project that you want to rebuild.
You can touch the MULTI SELECT button on the
PROJECT screen to allow the selection of multiple
projects.
3 Touch the MENU button on the PROJECT screen to
open a pull-up menu.
One project selected
Multiple projects selected
4 Touch the REBUILD button in the pull-up menu.
5 Touch the OK button or press the DATA dial when a
confirmation pop-up message appears.
During rebuilding, a progress status pop-up appears.
When rebuilding completes, the pop-up disappears.
NOTE
If you select REBUILD when no project has been selected
in the PROJECT screen, the entire content of the selected
card is rebuilt.
5–Projects