Owner's Manual

TASCAM DR-V1HD

5 – Taking still photos

Using the zoom in photo mode

This unit’s digital zoom allows you to zoom in on a subject before taking a

picture.

The digital zoom level is shown at the top right of the Home Screen.

You can adjust the zoom from 100%–400% (×1 to ×4 in 0.1 increments).

Press the zoom control towards W [m] to zoom out or T [,] to zoom in.

W [m]

Press the zoom control in this direction during recording or recording

standby to decrease the zoom level and widen the eld of view (W :

wide).

T [,]

Press the zoom control in this direction during recording or recording

standby to increase the zoom level and narrow the eld of view (T :

telephoto).

Using the self-timer in photo mode

Use the self-timer to take a photo a set amount of time after pressing the

RECORD button. This function works the same way as the self-timer of an

ordinary lm or digital camera.

On the Home Screen, press the F1( ) button to cycle through the self-

timer settings.

None

(”10 sec”)(”2 sec”)(”OFF”)

NOTE

You can also set the self-timer with the Self Timer item on the

REC

OPTION

screen.

Taking photos

The procedure below assumes that photo mode is active and the Home

Screen is open.

1. Press the RECORD or STOP/PAUSE button to put the unit into photo

standby.

The image that the camera will capture is shown on the screen in real

time.

In addition to the photo mode status, the image resolution, digital zoom

level (when zoom in use), white balance mode and current power supply

status are shown on screen.

At this time, you can use the zoom control to adjust the digital zoom.

2. Press the RECORD button to take a still photo.

For 2 seconds after being taken, the photo is shown without any

information indications.

3. Press the STOP/PAUSE button to exit photo standby.