User manual

tams elektronik
FCS modules English
Connection of the motor
Connect the enclosed diode 1N4148 to the connections of the motor.
Observe the polarity of the diode. Then connect the minus pole of the
motor to the switch switching the minus pole of the accumulator
batteries and to the connecting point X1. Next connect the collector (C)
of the enclosed transistor BC 327 to the plus pole of the motor, the
basis (B) to the connecting point X4 and the emitter (E) to the resistor
R7. If there is no resistor R7, connect the emitter directly to the plus
pole of the accumulator battery.
Connection of the LEDs for the flash lights
The two LEDs for the flash lights on the left or the right have to be
connected in series, i.e. the anode (+) of the one LED has to be
connected to the cathode (-) of the other LED. Next connect the
disconnected anode (+) with connecting point X5 (flash lights on the
right) or X7 (flash lights on the left) and the disconnected cathode (-)
with connecting point X3. Additional series resistors are not necessary
for the operation of the LEDs for the flash lights.
Connection of the LEDs for the stop and back lights
The two LEDs for the stop and back lights have to be connected in
series, i.e. the anode (+) of the one LED has to be connected to the
cathode (-) of the other LED. Next connect the disconnected anode (+)
with connecting point X6 and the disconnected cathode (-) with
connecting point X3. Additional series resistors are not necessary for
the operation of the LEDs for the stop and back lights.
Page 31