Model #TPPER94033 INSTALLATION GUIDE 10’x10’ Curved Roof Pergola
Operation 1 A2 A1A1 A1 B2 B1 C2 C1 □ Set aside all rafter pieces.Assemble the left rafter by inserting the left rafter,male (A1) into the left rafter,female (A2).Secure the top of the joined rafter with a plastic washer (DD) and M6*15 mm bolt (AA). Pipe Skirt Secure the bottom of the rafter with a washer (EE) and M6*15 mm bolt (AA). Slide the preassembled pipe skirt on the joined rafter.Secure pipe skirt with a washer (DD) and M6*15 mm bolt (AA).
Oper ation (continued) 2 D1 E1 D2 E2 □ Set aside all beam. Assemble the rear beam by inserting the rear beam, male (D1) into the rear beam, female (D2). Secure the of the joined beam with a plastic washer (DD) and M6*15 mm bolt (AA). Secure the bottom of the beam with a washer (EE) an M6*15 mm bolt (AA). DD Repeat this process for the front beam using the front beam, male (E1) and front beam, female (E2).
Oper ation (continued) 3 □ Slide one post skirt (J) onto each post 1 (H) and post 2 (I). H I Attach one plate (K) to each post 1 (H) and post 2 (I). Secure each with washers (EE) and M6*15 mm bolt (AA).
Oper ation (continued) 4 D1 D2 I H BB □ Attach rear beam (D1/D2) to post 1 (H) DD and post 2 (I). Secure with plastic washers (DD) and M6*95 mm bolts (BB). Repeat for front beam (E1/E2).
Oper ation (continued) 5 A1 A2 H I □ Attach left rafter (A1/A2) to the top BB of the beam and post assembly. Secure on both sides with plastic washers (DD) and M6*95mm bolt (BB). Repeat for right rafter (C1/C2).
Oper ation (continued) 6 □ D2/E2 Slide the pipe skirt on the center of the beam (D1D2/E1E2) as shown, then attach center rafter (B1/B2) to the top center of the beam. Secure with plastic washer (DD) and M6*95 mm bolt (BB). Repeat for four remaining center rafters (B1/B2).
Oper ation (continued) 7 L1 L2 L2 L1 □ Attach a brace (L1/L2) to the pergola assembly as shown. Secure with washers (EE) and M6*15 mm bolt (AA). Repeat for remaining braces (L1/L2).
Oper ation (continued) 8 N M N □ M Attach a brace (N/M) to the pergola assembly as shown. Secure with washers (EE) and M6*15 mm bolts (AA). Repeat for remaining brace (N/M).
Oper ation (continued) 9 □ Insert rod, male (G1) into rod, female (G2). Insert rod assembly into canopy (F). Repeat for remaining rod assembly.
Oper ation (continued) 10 F □ Place canopy (F) over pergola. Tie corners of canopy (F) to each post.
Oper ation (continued) 11 □ J Insert stakes (FF) into plate (K). Place post skirt (J) over plate (K). Repeat for remaining stakes (FF) and post skirts (J).