Installation Guide

ManualsBrandsTahanbath ManualsKitchen1-Handle 3-Spray Surface Mount Gooseneck Pull Down Sprayer Kitchen Faucet with Deckplate Not Included in Matte Black

Prior to Installation:

•

Pre-drilled countertop hole size requirement: 1-3/8”(min)

• Max countertop thickness: 3”

Tools you will need:

Wrench Phillips Screwdriver

Safety Goggles

Silicone Sealant

(optional)

Pipe Tape

Make sure you have all necessary parts by checking the diagram and parts list. If any

part is missing or damaged, please contact Kraus Customer Service at 303- 747-4321

for a replacement

Turn o the hot and cold water lines at the angle stops and turn on the old faucet to

release any built-up pressure

Summary of content (6 pages)

PAGE 1
Prior to Installation: • Make sure you have all necessary parts by checking the diagram and parts list.
PAGE 2
Diagram and Parts List A B C D E F J G H I A. Faucet Body B. Flange C. Rubber Washer D. Metal Washer E. Mounting Nut 2 F. Screws G. Weight H. Weight Clip I. Quick Connector J.
PAGE 3
Faucet Dimension (For KPF-2820) 10 5/8" [270.7mm] 3 1/2" 8 3/4" [222.9mm] 16 5/8" [423.7mm] [90.1mm] 8 7/8" [227.0mm] Ø2 1/4" 3" [76.5mm] [57.
PAGE 4
Step 1: Installing the faucet A F (2N.m Max) E Shut off the water supply. Place faucet (A) through the hole in countertop. Secure the faucet (A) to the countertop using the rubber washer (C), metal washer (D) and mounting nut (E) provided. Tighten screws (F). C D F Step 2: Securing the faucet assembly Push the quick connector (I) firmly upward and attach it to the receiving block (a). Pull down moderately to ensure the connection has been made.
PAGE 5
Step 3: Securing the faucet assembly Install the weight clip (H) at the point of the hose marking "weight here". Insert the weight (G) onto the weight clip (H) by sliding it down onto the weight clip (H). Weight here G Weight here H Step 4: Connect waterlines to main valve Attach waterlines to angle stops and tighten until snug.
PAGE 6
Step 5: Flush faucet Pull the hose assembly out of the spout and remove the spray head by unscrewing it from the hose in a counterclockwise direction. Be sure to hold the end of the hose down into the sink and turn the faucet on to the warm position where it mixes hot and cold water. Flush the water lines for one minute. This Fushesaway any debris that could cause damage to internal parts. Check for leaks. Re-tighten any connections if necessary, but do not overtighten.