Installation Guide

The procedure of sealing the wall
Use a parallel ruler lo measure the flatness of the embedded box casing and
the vertical wall surface.If the wall surface is not flat, ii should be patched
to ensure the embedded box casing and vertical wall angle meets al nearty
ideal angle of 90, then lay the tile decoration.
wall
Tile or wooden
surface
outside the
wall
≥25mm
10 INCH
Install the shower head
Handle shower installation
Installation of Rough-in valve
1.Take off the protective panel and cover
2. The decorative panel and the handle are connected to
the control valve as shown below sequence
According to the figure below , please correctly
adjust the direction of water separator handle
Top shower
outlet water
Shower double
outlet
Handle shower
outlet water
Handle shower
outlet water