Installation Guide

Prior to Installation:

•

• Pre-drilled countertop hole size requirement: 1 1/4”(min)

• Max countertop thickness: 3 1/16”

Tools you will need:

Adjustable Wrench Phillips Screwdriver

Safety Goggles

Silicone Sealant

(optional)

Supply Lines

Make sure you have all necessary parts by checking the diagram and parts list. If

any part is missing or damaged, please contact Kraus Customer Service at t 303-

747-4321 for a replacement

Turn oﬀ the hot and cold water lines at the angle stops and turn on the old faucet

to release any built-up pressure

PAGE 1
Prior to Installation: • Make sure you have all necessary parts by checking the diagram and parts list.
PAGE 2
Diagram and Parts List A G B C D E F A. Faucet Assembly B. Flange C. Rubber Washer D. Metal Washer E. Mounting Nut F. Connector G.
PAGE 3
Step 1: Preparing for installation Remove the rubber washer (C), metal washer (D), and mounting nut (E) from the end of the stud. C D E Step 2: Installing the faucet assembly A C D E 3 Place the faucet assembly (A) through the selected hole in the sink or countertop. On the underside of the sink or countertop, slide the rubber washer (C) and metal washer (D) onto the stud. Thread the mounting nut (E) onto the stud, and tighten securely using your wrench.
PAGE 4
Step 3: Connecting the quick connect adaptor and water line A Thread the quick connect adaptor (F) onto the end of the faucet assembly (A) stud, and tighten securely using a wrench. Connect the 3/8 in. water line from the filtration system by pushing the line into the connector (F). Pull down on the 3/8 in. line slightly to ensure the quick connect fitting has engaged. F 3/8 in.