Full Product Manual

ManualsBrandsT&S ManualsFaucet Valves3/8 in. Brass Add on Faucet in Chrome with Lever Handle

Installation and

Maintenance

Instructions

ADD-ON FAUCET

B-0155 (also used for

B-0156 and B-0157)

Deutsch: Installations- und

Wartungsanleitungen

Español: la Instalación y las

Instrucciones de

Mantenimiento

Français: les Instructions

d’Installation et

d’Entretien

Limited One Year Warranty

T&S warrants to the original purchaser (other

than for purposes of resale) that such product is

free from defects in material and workmanship

for a period of one (1) year from the date of pur-

chase. During this one-year warranty period, if

the product is found to be defective, T&S shall,

at its options, repair and/or replace it. To obtain

warranty service, products must be returned to...

T&S Brass and Bronze Works, Inc.

Attn: Warranty Repair Department

2 Saddleback Cove

Travelers Rest, SC 29690

Shipping, freight, insurance, and other trans-

portation charges of the product to T&S and the

return of repaired or replaced product to the

purchaser are the responsibility of the purchaser.

Repair and/or replacement shall be made within

a reasonable time after receipt by T&S of the

returned product. This warranty does not cover

Items which have received secondary finishing

or have been altered or modified after purchase,

or for defects caused by physical abuse to or

misuse of the product, or shipment of the prod-

ucts.

Any express warranty not provided herein,

and any remedy for Breach of Contract which

might arise, is hereby excluded and disclaimed.

Any implied warranties of merchantability or fit-

ness for a particular purpose are limited to one

year in duration. Under no circumstances shall

T&S be liable for loss of use or any special con-

sequential costs, expenses or damages.

Some states do not allow limitations on how

long and implied warranty lasts or the exclusion

or limitation of incidental or consequential dam-

ages, so the above limitations or exclusions may

not apply to you. Specific rights under this war-

ranty and other rights vary from state to state.

P/N: 098-012284-45

Date: 990316

Drawn: CW

Checked: MAB 4/6/99

Approved: MW 3/25/99

Summary of content (8 pages)

PAGE 1
Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/or replace it. To obtain warranty service, products must be returned to... T&S Brass and Bronze Works, Inc.
PAGE 2
Exploded View 8 9 10 7 5 11 12 13 2 1 4 3 5 6 * Some items are listed for instructional purposes and may not be sold as separate parts.
PAGE 3
Part Number Guide Add-On Faucet 1 2 3 4 5 6 Asm, Base Faucet B-0155, B-0156, B-0157 Body, Faucet Nipple, 3/8"x3" Asm, Qrtr-Turn Spindle Handle, Blank Lever Handle, 3-Wing Brass Screw, HandleUnit Lever Body, Swivel 3/8 005964-40 * 000358-40 007947-40 001638-45 011782-40 000922-45 Nozzle Assemblies 7 8 9 10 11 12 13 Asm, Swivel Nozzle - 6" Asm, Swivel Nozzle - 12" Asm, Swivel Nozzle - 18" Nut, Swivel Washer, Swivel Piece Swivel Piece Repair Kit*** Sleeve, Swivel O-Ring *** Kit includes items #12 & #13
PAGE 4
General Instructions Nozzle Installation: Note: Nozzles should be installed first. See diagram below: If installing to an existing rigid pre-rinse unit or base faucet 1. Shut off water supply and drain lines. Remove existing riser pipe from base faucet. Apply teflon tape or pipe joint compound to threaded ends of no.3. 2. Place no.3 into existing base faucet and tighten firmly by hand. pre-rinse riser 7 8 2 existing base faucet 3 To install Swing Nozzle: 3. Insert no.7 into no.
PAGE 5
Instrucciones Generales Instalación de la boquilla: Nota: Las boquillas deben ser instaladas primero. Vea el diagrama de abajo: Si esta instalando a una unidad existente de pre-enjuague rígida o a la base de canilla 1. Cierre la fuente de aguq y desagüe las tuberias. Remuéva el tubo de extensión existente de la base de la canilla. Aplique cinta de Teflon o compuesto de coyuntura a las extremidades enroscadas de la parte No.3. 2. Coloque la parte No.
PAGE 6
Instructions Générales L’Installation De L’Ajutage: Noter: Les ajutages devoir être installer au début. Voir le diagramme cidessous. Si vous installer un élément pré-rinçage rigide ou un robinet de la base. 1. Fermer la réserve de l’eau et égoutter la tuyauterie. Enlever le tuyau d’augmentation existant du robinet de la base. Appliquer le ruban en Téflon ou le composé pour les tuyaux a l’extrémité avec les filets de Nº.3. 2. Mettre Nº.
PAGE 7
Allgemeine Anleitungen Schwenkarm-Installation: Anmerkung:Die Schwenkarme sind als erstes zu installieren. Siehe Darstellung unten: Wenn er auf eine bestehende starre Vorspüleinheit oder auf ein vorhandenes Unterteil installiert wird: 1. Wasserzufuhr abstellen und Wasserleitungen entleeren. Bestehendes Steigleitungsrohr vom Unterteil entfernen. Teflonband oder Rohrkitt auf die Gewindeenden von Nr. 3 auftragen. 2. Nr. 3 in Hauptventil einfügen und mit der Hand festdrehen.
PAGE 8
T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, Travelers Rest, SC 29690 Phone: (864) 834-4102 Fax: (864) 834-3518 E-mail: tsbrass@tsbrass.