MSDS

Manufacturer: Crius Corp

Minnetonka, MN 55305

Emergency Phone: (877) 251-8295

Information Phone: (877) 251-8295

Effective Date: 2/5/2010

Section 1 - Identification

Product Name: T-MAT H.M.I.S

Chemical Family Asphalt Emulsion Health= 0

Fire= 0

Reactivity= 0

Section 2 – Ingredients

Ingredients CAS NO. WGT% Exposure Limits

Hazardous Ingredients OSHA A CGIH

PEL TLV

Asphalt Cement 8052-42-4 28-30 N/A 5.0 mg/m3

Listed in SARA Title III, Section 313-No.

LC 50 -N/A

LD 50 -N/A

STEL -N/A

Ball Clay* 1332-58-7 16-19 N/A 5.0 mg/m3

* Ball clays contain silica as quartz (CAS No. 14808-60-7) between 205-30% by dry

weight depending upon the manufacture. OSHA PEL for Quartz is 0.1 mg/m3.

LC 50 -N/A

LD 50 -N/A

STEL -5.0 mg/m3

Water 7732-18-5 48-50 N/A N/A

Listed in SARA Title III, Section 313 – No.

LC 50 -N/A

LD -N/A

STEL -N/A

Section 3 – Physical/Chemical Characteristics

Boiling Point Vapor Pressure Vapor Density Appearance & Odor

Greater than 212 deg F Nearly Equal to Water >1.0 Black liquid, Asphaltic smell

(mm Hg) Air = 1.0)

Specific Gravity (h2o=1) Melting Point Evaporation Rate (Butyl Acetate=1) pH

1.1 - 1.2 N/A approx 1.8 6.9 - 8.0

PAGE 1
Manufacturer: Emergency Phone: Information Phone: Effective Date: Crius Corp Minnetonka, MN 55305 (877) 251-8295 (877) 251-8295 2/5/2010 Section 1 - Identification Product Name: Chemical Family T-MAT Asphalt Emulsion H.M.I.S Health= Fire= Reactivity= 0 0 0 Section 2 – Ingredients Ingredients CAS NO. Hazardous Ingredients WGT% Asphalt Cement 28-30 8052-42-4 Exposure Limits OSHA A CGIH PEL TLV N/A 5.0 mg/m3 Listed in SARA Title III, Section 313-No.
PAGE 2
Section 4 – Fire and Explosion Hazard Data Flash Point (Method used) Flammable Limits N/A N/A LEL N/A UEL N/A Combustion Products Extinguishing Media CO, CO2, Hydrocarbons others Foam, dry chemicals, water fog, CO2, Unusual Fire and Explosion Hazards N/A Special Fire Fighting Procedures Full protective equipment, self-contained breathing apparatus. Sealed containers should be cooled to prevent steam from rupturing the container.
PAGE 3
Spill/Leak Procedures: Stop spill/leak at source. Confine spill with diking or other measures. Clean spill but do not allow material into sewer or water ways. Ventilate area to reduce the possibility of breathing vapor. Cleanup: Mix material with sand or other stable inert materials. Dispose of material properly- follow all local and federal laws. Regulatory Requirements: Notify local Officials if necessary. Follow all local or federal laws regarding disposal of solid waste.