Reel Installation

6
Installation
General Mounting Requirements
• (Fig. 2) Main-shaft must be horizontal.
• (Fig. 3a) Swivel inlet must be connected with  exible hose. Rigid pipe may cause
premature wear and a ect performance.
• (Fig. 3b) Centerline of spool assembly must be in-line with hose pull out. To adjust
guide arm, remove screws holding it to base and rotate to desired group of mount-
ing holes.
• Quali ed personnel must evaluate wall or ceiling fastening. Mounting through the
(4) 1/2” dia. holes on the base may vary due to surface materials. A possible method
for concrete, brick and cement block is a sleeve anchor type stud fastener ( g. 4)
instead of, sometimes di cult to install, long lag bolts.
Fig. 2
Fig. 3b
Fig. 4
Fig. 1
Fig. 3a
General Instructions