Installation

5
Sink Flange Tool
Figure 2
General Instructions
6. If Over ow is used (Figure 3) – Install the Over ow Head in the sink. The modular
design of the waste drain allows the over ow port on the Outlet to be positioned Left,
Right or Back. To change positions, remove the (4) cap screws with a 5/32” hex key
wrench and rotate the Outlet
to the desired position. If the
Outlet has been removed,
ensure the Valve Seal is either
in the Valve Body correctly
or installed on the Outlet lip
correctly. Install the (4) cap
screws and tighten. Measure
and cut the over ow tube
to  t into the Over ow Head
and Over ow Port on the
waste drain Outlet. Install the
Coupling Nuts and Seals on
the over ow tube. Install the
over ow tube and tighten the
connections.
Overflow Head
Overflow Tube
Outlet Adapter
Outlet
Overflow
Port
Seal
Coupling Nut
Figure 3
1. Remove the Snap-in Strainer and unscrew the Sink Flange Assembly from the Waste
Drain Assembly. Apply a bead of Plumber’s Putty to the bottom of the Sink Flange
Assembly where it contacts the sink bowl. (Keep the Drain Guard installed in the Sink
Flange Assembly at all times. Remove it only when clog maintenance is needed and
install it again when  nished).
2. Make sure the underside and inside mating surfaces of the sink bowl in the area of
the drain are clean.
3. Install the Waste Drain Assembly and Gasket from below the sink.
4. Install the Sink Flange Assembly thru the sink drain opening and screw it into the
Waste Drain Assembly below.
5. Before tightening, position the waste drain Handle to the desired location. Tighten
the Sink Flange Assembly securely with the Sink Flange Tool provided. (Figure 2)