Installation Sheet

Step 1A:
Remove Riser
from Base Faucet by
unthreading Easy Install
locking nut and pulling up
until the riser “pops” out.
Step 1B: Using a 3/8”
Allen Wrench, remove
Easy Install Bushing &
Locking Nut from riser.
Step 2A: Slide Easy
Install Nut onto base of
Add-on Faucet & Apply
Loctite 222 (or other non-
permanent thread lock
compound) to Add-on
faucet’s bottom threads.
Step 2B: Thread Easy
Install bushing over base
of Add-on faucet. Tighten
with a 3/8” Allen wrench.
Step 3A: After cleaning
with mild soap and water,
apply plumber’s tape or
putty to base threads of
riser.
Step 3B: Thread bottom
of riser into top female
section of Add-on Faucet.
Tighten.
Step 4A: The Add-on
Faucet & upper pre-rinse
assembly are ready to be
reconnected to the base
faucet.
Step 4B: Press the
bushing down into faucet
body and tighten locking
nut.
B-0155 Add-on Faucet
(pre-retrofit).
1A 1B
2A
2B
3A 3B
4A
4B
P/N:
098-014600-45
How to Install a T&S
Add-on Faucet on an
Easy Install PRU.
B-0155
B-0156
B-0157
T&S Brass and Bronze Works, Inc.
2 Saddleback Cove, P.O. Box 1088
Travelers Rest, SC 29690
TEL: [phone]
FAX: [phone]