Installation

5
To replace worn parts:
1. Shut o water supply and drain
lines. For ease of disassembly and
reassembly, the handle grip can be
removed from no.3.
2. Unscrew no.5 and no.6 to remove
no.4. Unscrew and remove no.16
from no.3.
3. Hold no.20 with pliers in one
hand, and with screwdriver, carefully
unscrew no.13 from no.16.
4. Apply no.21 over smooth portion
of no.13. Replace no.14, no.15, no.17,
no.18 & no.19 with new parts. Dab
no.21 onto valve side of no.19 before
replacing.
3
8. For EB-0107/UK-0107 & B-0107
ONLY: To replace no.9, unscrew
no.11 and disassemble. Make sure
the groove side of no.9  ts over
no.8, and no.10 rest on ridge side.
See Figure A.
9. To replace no.2, unscrew handle
grip from no.3 and replace with new
no.2.
10. Reassemble; turn on water check
for leaks.
1620
5
6
4
16
14
13
18
19
20
17
15
5. Reassemble no.16 by inserting
no.13 through all parts. Hold no.20
with pliers, and carefully screw no.13
into no.20 until screw feels tight. Do
not use excessive force.
6. Reinsert no.16 in no.3 and tighten
securely.
7. Reassemble no.4, no.5 and no.6
on no.3.
11. For EB-0107-C, EB-0107-J,
B-0107-C & B-0107-J ONLY: To
replace no.23, slide no.23 o no.25,
and slide a new no.23 back onto
no.25. No.23 will snap into groove
on no.25. See Figure B.
* Verify the  ow rate on no.23
matches spray tip inside no.25.
Caution: Turn o water supply at
base faucet when not in use.
Figure A
Figure B
11
10
9
8
1
3
23
13
apply no.21
here
2
handle
grip
25
General Instructions