IOM VLH VLC 704 1204

Table Of Contents

Page 12

For lifting operations, use only tools and ma-

terial fit for this purpose, in accordance with

accident-prevention regulations.

During the lifting and handling of the unit, be

careful not to damage the finned pack of the

coils positioned on the sides of the unit. The

sides of the unit must be protected by card-

board or plywood sheets.

It is recommended not to remove the pro-

tective plastic envelope, that should prevent

scraps from penetrating into the appliance

and any damage to the surfaces, until the

unit is ready for operation.

The lifting eyebolts protrude from the base of

the unit; it is therefore recommended to re-

move them once the unit has been lifted and

positioned, if in your opinion they are likely

to become a source of hazard and injury.

The eyebolts must be mounted on the unit whenever it

shall be displaced and then lifted again.

3.3 Anchoring

It is not essential to secure the unit to the foundations,

unless in areas where there is a serious risk of earth-

quake, or if the appliance is installed on the top of a

steel frame

Transport, Lifting and Positioning

WARNING

3.4 Storage

When the unit is to be stored before installation, adopt

a few precautions to prevent any damage or risk of

corrosion or wear:

n plug or seal every single opening, such as water fit-

tings

n do not store the appliance in a room where the tem-

perature exceeds 50 °C for the units using R410A

and, if possible, do not expose to direct sunlight

n minimum storage temperature is -25 °C

n it is recommended to store the unit in a roof where

traffic is minimized, to prevent the risk of accidental

damage

n the unit must not be washed with a steam jet

n take away and leave to the site manager all the keys

providing access to the control board

Finally, it is recommended to carry out visual inspec-

tions at regular intervals.