Installation, Operation and Maintenance instruction 001

ManualsBrandsSystemair ManualsFans & AccessoriesMUB/F 062 500D6 - Centrifugal box fan, 400°C/2h, insulated

Table Of Contents

1Introduction
- 1.1 Product description
- 1.2 Intended use
- 1.3 Document description
- 1.4 Product overview
  - 1.4.1 Product overview MUB/T fans and MUB/T-S fans
  - 1.4.2 Product overview MUB fans, MUB-CAV/VAV fans, and MUB/F fans
- 1.5 Name plate
  - 1.5.1 Type designation
- 1.6 Product liability
2Safety
- 2.1 Safety definitions
- 2.2 Safety instructions
- 2.3 Personal protective equipment
3Transportation and storage
4Installation
- 4.1 To do before the installation of the product
- 4.2 To install the product
5Electrical connection
- 5.1 To do before the electrical connection
- 5.2 To connect the product to the power supply
- 5.3 Speed controller for AC motors
- 5.4 To install motor protection for AC motors
- 5.5 Speed controller for EC motors
- 5.6 Motor protection for EC motors
6Commissioning
- 6.1 To do before the commissioning
- 6.2 To do the commissioning
7Operation
- 7.1 To start a product with an EC motor
- 7.2 To start a product with an AC motor
- 7.3 To stop the product
  - 7.3.1 To stop the product in an emergency
8Maintenance
- 8.1 Maintenance schedule
- 8.2 To clean the product
- 8.3 Spare parts
9Troubleshooting
10Disposal
- 10.1 To disassemble and discard the parts of the product
11Warranty
12Technical data
- 12.1 Technical data overview
- 12.2 Product dimensions
- 12.3 Wiring diagrams
13Accessory overview
- 13.1 Accessory overview MUB fans, MUB-CAV/VAV fans, MUB/T fans, MUB/T-S,MUB/T ECO and MUB+Filter fans
- 13.2 Accessory overview MUB/F fans
14EU Declaration of Conformity-Multibox
15EU Declaration of Conformity-Multibox+Filter
16EU Declaration of Conformity-Thermo fans
17EU Declaration of Conformity-Smoke extract fans
18UKCA Declaration of Conformity-Multibox
19UKCA Declaration of Conformity-MUB+Filter
20UKCADeclaration of Conformity-Thermo fans
21UKCA Declaration of Conformity-Smoke extract fans

EC-Vent

Demand control for up to 5 external sensors, 2 fans, damp-

ers, heaters and coolers.

The EC vent system has 2 units. The control board (CB) and

the room unit (RU). Connect the fan to the control board and

remove the internal potentiometer.

EC-Vent

IN/RPM

PWM

IN/10V

OUT/PWN

GND

TACH

optional

+10V

0...10V/PWM

GND

Room Unit (RU)

Br + 24VDC

Y +0-10V

Gr-

Bl (GND)

R+ 24VDC

Y +0-10V

W -

GND

24V

REF

24V