Installation, Operation and Maintenance instruction 001
Table Of Contents
- 1Introduction
- 2Safety
- 3Transportation and storage
- 4Installation
- 5Electrical connection
- 6Commissioning
- 7Operation
- 8Maintenance
- 9Troubleshooting
- 10Disposal
- 11Warranty
- 12Technical data
- 13Accessory overview
- 14EU Declaration of Conformity-Multibox
- 15EU Declaration of Conformity-Multibox+Filter
- 16EU Declaration of Conformity-Thermo fans
- 17EU Declaration of Conformity-Smoke extract fans
- 18UKCA Declaration of Conformity-Multibox
- 19UKCA Declaration of Conformity-MUB+Filter
- 20UKCADeclaration of Conformity-Thermo fans
- 21UKCA Declaration of Conformity-Smoke extract fans
10 Disposal
The product follows the WEEE directive. This symbol on the
product or the packaging of the product shows that this
product is not domestic waste. The product must be recycled
at an approved disposal location for electrical and electronic
equipment.
10.1 To disassemble and discard
the parts of the product
1 Disconnect and disassemble the product in the opposite
sequence of electrical connection and installation.
2 Recycle the product parts and the packaging at an appli-
cable disposal location.
3 Obey the local and national requirements for disposal.
11 Warranty
For warranty claims, send a written maintenance plan and
the commissioning report to Systemair. The warranty is only
applicable for these conditions:
• The product is correctly installed and operated.
• Motor protection is used.
• The instructions in the data sheets are obeyed.
• Maintenance instructions are obeyed.
• A product that is not operated continuously is operated for
a minimum of 1 hour each month.
16