SYSLOGIC – Installation Operation Manual (IOM LOGIC 02 N 3GB)

English
3 4 5
CTRL
GND
SIG
12 V
GND
SIG
12 V
12 V
SIG
GND
Mode
Main Board
Infrared receiver
3 4 5
CTRL
Main Board
12 V
SIG
GND
Mode
3 4 5
CTRL
GND
SIG
12 V
GND
SIG
12 V
12 V
SIG
GND
Main Board
Infrared receiver
GND
SIG
3 4 5
CTRL
3 4 5
CTRL
GND
SIG
3 4 5
CTRL
GND
SIG
12 V
GND
SIG
12 V
12 V
SIG
GND
Mode
Main Board
Main Board Main Board
Infrared receiver
Lorem ipsum
A single water sensor must be installed per zone, on the rst fan convector unit.
Caution
15 cards maximum, a greater number could set off a re.
Caution
13SYSLOGIC
Control with MRC/WRC remote
terminal or infrared remote control
only
Control with WRC remote terminal
or infrared remote control and BRC
remote terminal
Control with BRC remote terminal
only
By way of a summary of the concepts expressed in preceding paragraphs, with reference to the gure
above, the situations described below would be possible.
² One single, "stand-alone" unit could be equipped with a MRC/WRC remote terminal or infrared
remote control.
² In the case of a single fan coil, it would also be possible to use the BRC remote terminal in
conjunction with the WRC remote terminal or infrared remote control (case 2). The BRC remote
terminal would make it possible to increase/decrease the control parameters set on the WRC remote
terminal.
² If multiple units are interconnected in a "zone", the presence of a (single) MRC/WRC remote terminal
or infrared remote control, becomes mandatory. At most, the other units would be equipped with
a BRC remote terminal. It is not permissible for a zone to consist only of units with BRC remote
terminal.
² It is possible for a network of fan coils to consist of units equipped with AC and / or EC motors. The
different fan coil can also have different set up of the 3-dip switches.
5. MANAGEMENT OF THE FAN COILS AND CONNECTIVITY
5.1. MANAGEMENT INDIVIDUALLY WITHOUT BMS
5.2. MANAGEMENT BY ZONES WITHOUT BMS