IRC – Installation Operation Manual (IOM IRC 01 N 2ALL)

NTC - IR2

GB - 4

General information

The remote control works only with hydronic units.

For installation instructions of this unit, refer to the relevant

manuals.

The operating setting to the unit are sent by the remote control

through an infrared ray.

The emitter is placed on top of the remote control just over the

display (H).

For this reason, the remote control must be directed towards the

unit before sending any message and care must be taken that no

obstructions are between the remote control and the unit.

A small black arrow on the display left side indicates that the

message has been correctly sent.

An acoustical sound (beep) indicates that the message has been

correctly received by the unit.

• For trouble-free installation, which should be carried out by a

Wall-mounted bracket

qualified installer.

• Follow all current national safety code requirements.

• After installation thoroughly test the system operation and

explain all system functions to the owner.

• Leave this manual with the owner for consultation during

future periodic maintenance.

• Dispose of packaging material in accordance with local

requirements.

• The manufacturer denies any responsibility and warranty

shall be void if these installation instructions are not

observed.

• Inspect equipment for damage due to improper transportation

or handling: file an immediate claim with the shipping

company. Do not install or use damaged units.

• In case of any malfunctioning turn the unit off, disconnect the

mains power supply and contact a qualified service engineer.

25 mm

0,984 in

5 mm

0,196 in

IRC