SYSLOGIC – Installation Operation Manual (IOM LOGIC 02 N 3GB)

English
The green LED ashes for 20 seconds. During this period, changes can be made. The three parameters
(Address, Parity and Speed) are updated during the validation phase. The unit must be rebooted for
the parameter changes to be effective.
Caution
Cfg:
AUTO
ON
Infrared receiver
Cfg:
AUTO
5S
FLASH
Infrared receiver
Adr:
AUTO
Adr:
AUTO
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
5S
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
Cfg:
AUTO
Cfg:
AUTO
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
5S
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
Auto
Max
Med
Min
—M-Adr
Ok
+
M-Cfg
Mode
On
Off
12 SYSLOGIC
4.3.3. MODBUS PARAMETER MODIFICATION
The IR remote control is used for setting the parameters of the MODBUS communication protocol:
² Address
² Parity bits
² Transmission speed.
4.3.3.1. ADDRESSING
4.3.3.2. PARITY/SPEED
The conrmation beep sounds.
The conrmation beep sounds.