IMO FRQ5S 4A 10A 16A V2
Table Of Contents
- 1 General notes
- 2 Safety instructions
- 2.1 Intended use
- 2.2 Explanations of symbols
- 2.3 Product safety
- 2.3 Product safety
- 2.4 Requirements placed on the personnel / due diligence
- 2.4 Requirements placed on the personnel / due diligence
- 2.5 Start–up and during operation
- 2.5 Start–up and during operation
- 2.6 Working on device / Hazards through
- 2.7 Modifications / interventions in the device
- 2.8 Operator’s obligation of diligence
- 2.9 Employment of external personnel
- 3 Product overview
- 4 Mounting
- 5 Electrical installation
- 5.1 Safety precautions
- 5.2 EMC–compatible installation
- 5.3 Mains connection
- 5.4 Residual–current–operated protective device
- 5.5 Inverter output
- 5.6 Motor protection
- 5.7 Voltage supply for external devices (+, GND)
- 5.8 Enable, Device ON / OFF (Digital In 1 =D1)
- 5.9 Relay outputs
- 5.10 Bypass circuit
- 5.11 Potential at control voltage connections
- 6 Start–up
- 7 Diagnostics / Faults
- 8 Enclosure
4.3 Outdoor installation
Outdoor installation is possible up to -20 °C when the controller supply is not switched
off. Installation must be protected from the effects of weather as much as possible,
including protection from direct sunlight!
4.4 Installation location for agriculture
In order to avoid damage caused by ammoniac vapours, the controller shall not be
installed in the stable, but rather in an outhouse wherever possible.
4.5 Temperature influences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by
storing the controller at room temperature!
5 Electrical installation
5.1 Safety precautions
Danger due to electric current
•
Work on electric components may only be carried out by trained electricians or
by persons instructed in electricity under the supervision of an electrician in
accordance with electrical engineering regulations.
•
The 5 electrical safety rules must be observed!
•
It is forbidden to carry out work on electrically live parts. Even after disconnec-
tion, the dc-link is still live. Always wait at least 3 minutes.
•
Other measures may be necessary to achieve safe electrical isolation.
•
A second person must always be present when working on energized parts or
lines who disconnects in case of emergency.
•
Inspect electrical equipment periodically: retighten loose connections – imme-
diately replace damaged lines and cables.
•
Always keep switch cabinets and all electrical supply facilities locked. Access
is only allowed for authorized persons using a key or special tool.
•
Operating the device with the housing cover removed is prohibited because
energized, exposed parts are present inside the device. Disregarding this regu-
lation can lead to severe personal injury.
Operating Instructions FRQ5S-4/10/16A Electrical installation
L-BAL-E197-GB 1445 Index 002 Part.-No. 00163411-42
11/26