OPERATION AND MAINTENANCE INSTRUCTION TOPVEX SR TR 254051A003
Table Of Contents
- 1 Overview
- 2 Warnings
- 3 Warnings signs on product
- 4 Product description
- 5 Internal components position
- 6 Start up
- 7 Operation
- 8 Maintenance
- 8.1 Maintenance intervals
- 8.2 How to replace supply/extract air filter
- 8.3 How to clean NaviPad
- 8.4 How to clean the heat exchanger
- 8.5 Control of the heat exchanger
- 8.6 How to clean fans
- 8.7 How to clean hot water heating coil
- 8.8 How to clean electric heating coil
- 8.9 How to clean the extract air louvres and inlet diffusers
- 8.10 Clean the outdoor air intake
- 8.11 How to clean the duct system
- 8.12 Where to reset tripped fuses
- 8.13 How to reset the manual overheat protection (EL units)
- 8.14 How to replace the fan module
- 8.15 How to replace the heat exchanger
- 8.16 Change the internal battery in control unit CU27–C
- 9 Troubleshooting
- 10 Alarms
- 11 Service
- 12 General conditions
Maintenance
|
25
8.15 How to replace the heat exchanger
Caution
• Handle the heat exchanger carefully.
• The heat exchanger is heavy.
1. Open the air handling unit’s doors.
2. Note the position of the purge sector.
3. Loosen the door beam (only SR/TR 20-35, figure 7).
Fig. 7
4. Loosen the locking plate, figure 8.
x2
Fig. 8
254051 | A003