Configuration Manual

Version Document ID
A
001 Access_Function_description_B001.docx
45 (56) 2018-07-11
Note! If you not finde your device, se 25.2 to configure/activate your device
Signal
Selecta I/O for signal on selected device.
Note! It’s possible to select an already used I/O position.
Please select the same ouputs as wiring diagram describe.
Or select a free I/O’s position.
22.4 Digital outputs
Configure: Configuration > I/O allocation
Digital outputs shows only actuator/signals as are activade by configuration
Note! If the sensor/signal is not in the list, please activate and configure the
function and go back in this list to set up a physical position of I/O's
Digital outputs Device Signal
e.g Sequence-A start Controller DO1
Avalible analogue outputs
 Sequence-A start
 Sequence-B start
 Sequence-C start
 Sequence-D start
 Sequence-E start
 Sequence-F start
 Sequence-G start
 Sequence-H start
 Sequence-I start
 Sequence-J start
 Sequence-A pump
 Sequence-B pump
 Sequence-C pump
 Sequence-D pump
 Sequence-E pump
 Sequence-F pump
 Sequence-G pump
 Sequence-H pump
 Sequence-I pump
 Sequence-J pump
 Supply air fan start
 Extract air fan start
 Recirculation air damper
 Outdoor air damper
 Exhaust air damper
 Fire damper
 Alarm 1
 Alarm 2
 Summary Alarm
 Extra fan motor 1 start
 Extra fan motor 2 start
 Extra time channel 1
 Extra time channel 2
 Extra time channel 3
 Extra time channel 4
 Free cooling running
 Pretreatment start
 Running indication
 Step controller 1 step 1
 Step controller 1 step 2
 Step controller 1 step 3
 Step controller 1 step 4
 Step controller 2 step 1
 Step controller 2 step 2
 Step controller 2 step 3
 Step controller 2 step 4
 Dehumidify/(Humidify)
 Changeover 1
 Changeover 2
 Outdoor controlled exchanger
Device
Select controller or some off the other device
Note! If you not finde your device, se 25.2 to configure/activate your device
Signal
Selecta I/O for signal on selected device.
Note! It’s possible to select an already used I/O position.
Please select the same ouputs as wiring diagram describe.
Or select a free I/O’s position.
Alarm configuration
Configure Configuration > Alarm configuration
Information about individually configuring each unique alarm settings