Manual

Before you start
JnstaRing batteries in the remote control
Install two "AA" size batteries (suppHied), matching
their poHarity to those indicated inside battery corn°
partment of the remote controH.
Note:
Incorrect use of batteries can resuHt in hazards such
as Heakageand bursting. PHeasefollow the instruction
bellow:
° Do not mix new and oHd batteries together.
° Do not use different kinds of batteries together.
AHthough they may Hook similar, different batteries
may have different voltages.
° Hake sure that the pHusand minus ends of each
battery match the indications in the battery corn=
partmenc
° Remove batteries from equipment that is not going
to be used for a month or more.
° When disposing used batteries, pHeasecompHy with
governmental reguHations or pubHic tulles for envi=
ronmentaH protection that appHyin your country
or area.
° Do not recharge, short-circuit, heat, burn or disas-
sembHe batteries.
Using a remote control
Keep in mind the following when using the remote
controH:
° Hake sure that there is no obstacHe between the
remote controH and the remote sensor of the
unit.
° Remote operation may become unreHiabHeif
strong sunHight or fluorescent Hightis on the
remote sensor of the unit.
° Remote controH for different devices can inter-
fere with each other. Avoid using remote controH
for other equipment Hocated chose to the unit.
° RepHacethe batteries when you notice a faHH-off
of the operating range of the remote control
° The maximum operabHe ranges from the unit are
as follows.
- Beeline: approx. 23 feet (7m)
- _:ither side of the center:
approx. 16 feet (5m) within 30°
= Above: approx. 16 feet (Sin) within 15°
- Below: approx. 10 feet (3m) within 30 °
Within about
23feet (7m)
Remote
control
TheVCR/DVD recorder Switching
Because this product is a combination of aVCR and a DVD recorder, you must seHect first which corn=
ponent you wish to operate with [OUTPUT SELECT].
VCR MODE
Hit [VCR] on the remote controH.
(Verify that theVCR indicator is Hit.)
DVD MODE
Hit [DVD] on the remote control
(Verify that the DVD indicator is Hit.)
Note
o Hitting onHy [OUTPUT SELECT] on the
front paneH DOES NOT switch the mode of the
remote controH.You MUST seHect the correct
mode on the remote controH.
oYou cannot switch to another mode (DVD or
VCR) during in the timer=standby mode.
" Pressing [REC/OTR] (DVD) or [REC/OTR]
(VCR) on the remote controH switches immedi=
ateHyits respective mode so that you can start
recording directly on the appropriate media.
OUTPUT SELECT button
VCR button
DVDbutton
DVD indicator
..............................VCRindicator
OOO_
666
'_@6@
10