Operation Manual

ManualsBrandsSwiss Kraft ManualsToolsSK2000

780w 2 STROKE GENERATOR SML34GEN

OPERATION INSTRUCTIONS

Warning: Before using your generator be sure to

read the instruction manual carefully.

1. ASSEMBLY

Fit the carrying handle to the top of the petrol tank and

secure in position using the 2 screws provided (See fig

2).

2. LOCATION & GROUNDING

Before using this generator it must be prepared

correctly before use. Locate the generator on firm level

ground away from buildings or other structures

ensuring that the exhaust is not obstructed.

Warning: It is advisable to properly earth-ground your

generator before starting using a wire and a small earth

stake.

Note: The wire and earth stake are not supplied with

the unit.

Earth Spike and Cable can be purchased at your local

camping supplies, or alternatively an Earth spike can be

made, and it is suggested you get advice from a

registered electrical trades person.To make a Spike use

a Copper tube or Copper Rod 12mm diameter, a

minimum length of 200mm and with an M6 Machine

screw one end.The cable used should be a Maximum

length of 1 metre and a Minimum of 1.0mm2 to carry a

10amp load.The cable should be attached to the

Generator at the Earth point (See fig 3) and to the

Spike between a flat washer and the Copper with a lock

washer under the head of the M6 Machine screw in a

similar fashion to the Earth point screw on the

generator.

When placing the Spike into the ground the Generator

must not be running and it is suggested that the Spike is

pushed into the ground by at least 100mm so that it is

firm and a litre of water poured around it to ensure

good Earth continuity.

Fig 3

Fig 2

Summary of content (4 pages)

PAGE 1
OPERATION INSTRUCTIONS Warning: Before using your generator be sure to read the instruction manual carefully. 1. ASSEMBLY Fit the carrying handle to the top of the petrol tank and secure in position using the 2 screws provided (See fig 2). Fig 2 2. LOCATION & GROUNDING Fig 3 Before using this generator it must be prepared correctly before use. Locate the generator on firm level ground away from buildings or other structures ensuring that the exhaust is not obstructed.
PAGE 2
3. FUELING The generator is powered by a two-stroke engine, which uses a petrol oil mix fuel.The correct fuel mixture is a ratio of either 50:1 or 40:1 of petrol and two stroke oil (depending on the ambient temperature) i.e. 50 parts of unleaded petrol to one part of twostroke oil. Warning! Use only genuine two-stroke oil. 1L : 0.02L 2L : 0.04L Fuel mixing The fuel tank has a maximum capacity of 4.5L.To mix the fuel correctly use the filler cap gauge to measure the correct amount of oil to petrol.
PAGE 3
Fig 7 Set the choke lever to the ON position (See fig 7). Turn the engine ON/OFF switch to the ON position (See fig 8). Hold down the generator firmly with one hand on the carrying handle.With the other hand grip the recoil starter cord handle and pull slowly until resistance is felt indicating that the recoil starter is engaged.When resistance is felt pull the cord sharply (See fig 9). Continue this procedure until the engine starts.
PAGE 4
5. STOPPING THE GENERATOR ENGINE Before stopping the engine, switch off all the electrical loads and turn the generator ON/OFF switch to the OFF position (See fig 11). Before stopping the engine make sure that all the electrical loads are disconnected from the generator AC outlet socket. When the generator engine has stopped and before storage, turn the fuel cock lever to the OFF position as shown in Fig 12. Fig 11 6.