Zero Turn Riding Mower Owner's Manual

Parking Brakes
SERVICE & ADJUSTMENTS
25
ITEM # DESCRIPTION PART #
1 Weldment; Rod Mount - ZTR Brake 13190
2 Plate; Clasp - ZTR Brake 13191
3 Weldment; Rod Pivot 13195
4 Weldment; ZTR Brake Linkage - Left 13202
5 Weldment; ZTR Brake Linkage - Right 13198
6 Spacer B99S
7 5/16-18 x 3/4 FLANGE BOLT NB596
8 5/16-18 SERR FLANGE NUT NB170
9 Weldment; Push Rod, ZTR Brake 13207
10 SHIFT KNOB B19
11 3/32 X 1 Cotter Pin NB708
12 1/4-20 Flange Nut NB524
13 5/16-18 Jam Nut NB173
14 1/4-20 X 3/4 Flange (Self Cutting) NB690
15 Two Speed Spring (AZ32 1998) TZ2S
16 1/4 SAE Washer NB274
17 1/4-20 Nylok Nut NB180
18 Weldment; Rod 5/16-18 x 11 1/2; 2 1/2
E
13208
19 Link - Clutch Chain T2L
9 The Swisher ZT2350A is equipped with a Parking Brake system activated by pulling
the brake knob (10) up.
9Adjustment for the system is located on the ends of the brake weldment rod (18).
9 Raise the rear wheel off the ground.
9 Disengage the hydro to be adjusted with the hydro release handle at the rear of the
unit
9Adjust so that the brake is not on when the handles are in the operator position. The
wheel should turn freely.
9 The wheel should not turn when the brake is engaged.
9 To tighten the brake, turn the adjustment nuts towards the end of the cable.
9 Recheck adjustment with control handle
9 Lower unit back to the ground
9Reengage the hydro at the rear of the unit