SDS

5
Protect from physical damage.
B. CONDITIONS FOR SAFE STORAGE (INCLUDING ANY INCOMPATIBILITIES)
Avoid contact with eyes. Store in a cool, dry, ventilated area away from sources of heat, moisture, incompatibilities, and direct
sunlight. Have emergency equipment (for fires, spills, leaks, etc.) readily available.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
A. OCCUPATIONAL EXPOSURE LIMIT(S), BIOLOGICAL EXPOSURE STANDARD
OSHA-PEL 0.05 mg/m3 (Lead), 1 mg/m3 (Sulfuric acid), 0.5 mg/m3 (Antimony)
ACGIH-TLV TWA 0.05 mg/m3 (Lead), TWA 0.2 mg/m3 (Sulfuric acid, TWA 0.5 mg/m3(Antimony)
B.APPROPRIATE ENGINEERING CONTROLS
Use local exhaust ventilation if necessary to control airborne mist and vapor.
C. INDIVIDUAL PROTECTION MEASURES
Respiratory protection: If significant mists or aerosols are generated an approved respirator is recommended. If respiratory
protection is required, institute a complete respiratory protection program including selection, fit testing, training, maintenance
and inspection.
Eye protection Wear safety glasses with side shields (or goggles).
Hand protection: Wear chemical resistant gloves. Gloves should be replaced immediately if signs of degradation are observed.
Body protection: Use good work and personal hygiene practices to avoid exposure. Consider the provision in the work area of a
safety shower and eyewash. Always wash thoroughly after handling chemicals.
9. PHYSICAL AND CHEMICAL PROPERTIES
A. APPEARANCE (PHYSICAL STATE, COLOUR etc.): Off-white cloudy liquid with solid object.
B. Odor: Characteristics.
C. ODOR THRESHOLD: Not available.
D. pH: pH < 1 (Sulfuric acid)
E. MELTING POINT/FREEZING POINT: Not available.
F. INITIAL BOILING POINT AND BOILING RANGE: Not available.
G. FLASH POINT: Non-flammable.
H. EVAPORATION RATE: Not available.
I. FLAMMABILITY (SOLID, GAS): Not applicable.
J. UPPER/LOWER FLAMMABILITY OR EXPLOSIVE LIMITS: Non-Flammable
K. VAPOR PRESSURE: Not available
L. SOLUBILITY: Soluble in water.
M. VAPOR DENSITY: Not available
N. SPECIFIC GRAVITY: Not available
O. PARTITION COEFFICIENT OF n-OCTANOL/WATER: Not available.
P. AUTO-IGNITION TEMPERATURE: Not applicable.
Q. DECOMPOSITION TEMPERATURE: Not available.
R. VISCOSITY: Not available.
S. MOLECULAR WEIGHT: Mixture.
Note: These physical properties are typical values for this product.
A. APPEARANCE (PHYSICAL STATE, COLOUR etc.): Bluish white, silvery gray.
B. Odor: None.
C. ODOR THRESHOLD: Not available.
D. pH: Not applicable.
E. MELTING POINT/FREEZING POINT 327.5 C
F. INITIAL BOILING POINT AND BOILING RANGE 1740 C (1013hPa)