Installation Guide

SwanStone_07/18/06

STEP 4

Vinyl Sweep Insert & Door Frame Installation

Center shower enclosure on base ledge. Using the Panel Ex-

pander Jamb adjustment holes as guides . . . fasten Side Panels

(B) to Wall Jambs (A) using three (3) #6 x 3/8" self drilling panel

adjustment screws (G) as shown in figure 4c.

Place Door Frame Assembly (C) between the Side Panels (B).

Starting with the pivot side first . . . engage the length of the Panel

Assembly with the Door Assembly as shown in figure 4b. Secure

Door Frame Pivot Post to the Side Panel with three (3) #8 x 3/4"

flat head screws (F). Repeat procedure for the Strike Post side.

Measure the Door Assembly width, then trim the Vinyl Sweep to

3/8” less than measurement obtained (see figure above).

Notch end of Vinyl Sweep as shown. Determine bottom of Door

Assembly and insert Vinyl Sweep into bottom rail. Insert 3/32”

notched end first.

STEP 6 Caulk for a leak proof installation

Fig. 4c

Fig. 4b

Fig. 5

TO INSURE A LEAK PROOF INSTALLATION:

First: Run a bead of clear mildew resistant caulking around the

outside of shower enclosure where shower unit meets the shower

base (see figures 5 and 5a).

Second: From inside the shower unit, caulk the six (6) circled

areas indicated in figure 5 above (caulk the crevice where the

horizontal member meets the vertical member as shown in fig 5b).

Fig. 5a Fig. 5b

Carefully follow caulking manufacturer's instructions before using

shower.