Installation Guide

WARNING: Continued
Power Tool Hazard
To prevent personal injury or possible
death, always follow the electrical safety
recommendations of the power tool’s
manufacturer. Do not use power tools in an unsafe
manner. Power tools should only be connected to a circuit
protected by a ground-fault circuit interrupter (GFI).
Shock Hazard
Never use electric power tools around
water, condensation, or other liquids.
Electric shock can cause severe
burns, significant injuries, and even death. If an
extension cord is required, always use an OSHA
approved extension cord. Power cords should only be
connected to a circuit protected by a ground-fault circuit
interrupter (GFI).
Electrical Shock Hazard
Contacting l
ive electrical wiring with
power tools or hand tools can cause
serious injury or death. Make sure all
related circuit breakers are turned OFF. Test for live circuits
or wiring inside any wall where installation of the
Swanstone product requires cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric
current and can create a short circuit,
resulting in injury or death. Keep all
liquids away from electrical cords and power tools. DO
NOT create a short circuit between a source of electricity
and a liquid by being in contact with both simultaneously.
General Information
Required Tools
 Circular saw with 60 to 80 tooth carbide blade
 Saber saw (straight up and down travel) with
bi-metal blade (14 teeth per inch)
 Drill with 3/8” drill bit
 Hole saw for shower faucet/shower head
 Tape measure
 Masking tape (2” wide works best)
 Level
 Compass or dividers (scribe the panel to the wall)
 Caulking gun
 Clean paper towels or shop towels
 2 x 4 lumber as required for bracing (see Bracing
Instructions)
 Industrial grade, hot glue gun and glue sticks
(optional)
 Denatured Alcohol
Kit Contents
Confirm that all parts of this kit have been included
before beginning installation.
WARNING
The Swan Corporation – Swanstone 6 800-325-7008
Safety Guidelines General Information