Installation Guide

1. Place two or three braces against the back wall.
Place two braces on panels that are 48” or less and
three braces on panels greater than 48” wide.
2. Place two braces against each left and right wall.
3. Install (wedge) three horizontal braces (six total)
against the left and right wall braces.
4. Insert small blocks between the front to rear panel
braces and the back panel braces. These will apply
pressure to the back panel to hold it in place.
5. Remove the braces after 24 hours.
Installation Procedure
800-325-7008 17 The Swan Corporation – Swanstone